EX-ProdukteETN® Autor Markus Weber erklärt uns die Besonderheiten unserer EX-geschützen Produkte für den Aufzug/Fahrstuhl Bereich. Wo sollte man Explosionsge...

Guide holder HSML 180, for inserts EL 9 - 28 mm, 180 x 120 x 65 mm

Item number: 300004

Guide holder WSML 180, for inserts EL 9 - 28 mm, 180 x 120 x 164 mm

Item number: 300011

Guide holder HSMLS 180 mm, GGG 40, for inserts EL 9-28 mm (PE-inserts), 180 x 120 x 65 mm

Item number: 300078

Insert EL 16 PEE for guide holder HSML + WSML, rail width 16mm, 180 x 36,5 x 50 mm,, foldable, ETN-HM-1000-E, surface resistivity 10^7 W (DIN IEC 60093). The friction of moving parts may cause b...

Item number: 309014-E

Available immediately

Technical data

Identical in construction to the manufacturer:	ETN
Insert width:	36,5 mm
Insole height:	30 mm
Insole length:	180 mm
Material:	PEE (Polyethylene ETN®-HM-1000-E) discharge
Rail width:	16 mm
Suitable for holding shoes:	HSML 180 (Art.-Nr.: 300004), HSMLS (GG) 180 (Art.-Nr.: 300078), WSML 180 (Art.-Nr.: 300011)

Description

Insert EL 16 PEE for guide holder HSML + WSML, rail width 16mm, 180 x 36,5 x 50 mm,, foldable, ETN-HM-1000-E, surface resistivity 10^7 W (DIN IEC 60093).

The friction of moving parts may cause big differences of potential. Arising voltage punctures might lead to an ignition of flammable substances. This could cause serious consequences in explosion-proof areas (e.g. chemical, mining, paint industry). To protect against electrostatic discharges (ESD), rapid discharges should be avoided. Below listed materials are conform to the protection category „conductive“ (surface resistance between 100 Ohm and 100 kOhm) and
„static dissipating“ (surface resistance between 100 kOhm and 100 GOhm).

Guide inserts out of ETN®-HM -1000-E have antistatic agents
and are characterized by a special surface resistance of
about 107 Ohm (DIN IEC 60093). Therefore the material is electrically
conductive and does not pick up static charging.